Revolution Design Audio 550.1D Series Amplifier
The RD series amplifiers deliver a ton of power with a low distortion
rate. We used the best parts we could find to give you a top quality
amplifier that anyone would be proud to show off. With their clean
looks and sleek finish, they’ll look good in any install. So whether it’s
an elegant sound quality setup or a high powered SPL vehicle, the
RD series amplifiers have you covered.
All Class D models have variable subsonic filters
Class D amps are over 90% efficient
18 db crossover slope on all AB and D series amplifiers
All models have an variable 18 db bass boost
Features:
Digital class-D linkable mono block amplifier
MOSFET PWM power supply
Daisy-chain through output RCA
Double sided through hole epoxy PCB
Stable into 1 ohm load workable
24dB/oct, fully variable low pass (LPF) crossover
24dB/oct, fully variable subsonic filter
18dB/oct, fully variable adjustable bass-boost
Variable frequency for bass boost
Efficiency: 86% @ 4 ohm, 100 Hz
Multi-way protection circuitry (Thermal/over current/speaker
short/speaker dc protection)
RCA line input
Tested voltage & THD : 14.4V & less than 1% THD
Operating voltage : DC 10V~16V power input
Wired remote controller
Specifications:
RMS power, 1 ohm mono 550w x 1ch
RMS power, 2 ohm mono 350w x 1ch
RMS power, 4 ohm mono 200w x 1ch
Signal to Noise Ratio >100dB
Low pass frequency crossover 35Hz~300Hz
Subsonic filter 10Hz~60Hz
Bass boost @ 45Hz 0~18dB
Bass boost control 35Hz~120Hz
Frequency response 10Hz~350Hz (+/- 1dB)
T.H.D @ 4 ohm <0.1%
Efficiency @ 4 ohm 86%
Fuse rating 20A x 3
Input Sensitivity 200mV to 6V (+/- 5%)
Dimensions 222(W) x 52(H) x 270(L)mm
Click for product manual ››
The RD series amplifiers deliver a ton of power with a low distortion
rate. We used the best parts we could find to give you a top quality
amplifier that anyone would be proud to show off. With their clean
looks and sleek finish, they’ll look good in any install. So whether it’s
an elegant sound quality setup or a high powered SPL vehicle, the
RD series amplifiers have you covered.
All Class D models have variable subsonic filters
Class D amps are over 90% efficient
18 db crossover slope on all AB and D series amplifiers
All models have an variable 18 db bass boost
Features:
Digital class-D linkable mono block amplifier
MOSFET PWM power supply
Daisy-chain through output RCA
Double sided through hole epoxy PCB
Stable into 1 ohm load workable
24dB/oct, fully variable low pass (LPF) crossover
24dB/oct, fully variable subsonic filter
18dB/oct, fully variable adjustable bass-boost
Variable frequency for bass boost
Efficiency: 86% @ 4 ohm, 100 Hz
Multi-way protection circuitry (Thermal/over current/speaker
short/speaker dc protection)
RCA line input
Tested voltage & THD : 14.4V & less than 1% THD
Operating voltage : DC 10V~16V power input
Wired remote controller
Specifications:
RMS power, 1 ohm mono 550w x 1ch
RMS power, 2 ohm mono 350w x 1ch
RMS power, 4 ohm mono 200w x 1ch
Signal to Noise Ratio >100dB
Low pass frequency crossover 35Hz~300Hz
Subsonic filter 10Hz~60Hz
Bass boost @ 45Hz 0~18dB
Bass boost control 35Hz~120Hz
Frequency response 10Hz~350Hz (+/- 1dB)
T.H.D @ 4 ohm <0.1%
Efficiency @ 4 ohm 86%
Fuse rating 20A x 3
Input Sensitivity 200mV to 6V (+/- 5%)
Dimensions 222(W) x 52(H) x 270(L)mm
Click for product manual ››
|
|
|
 |  |  |  |  |  |  |  |  |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 | |  |
 | |  |
|
| The Finest High End Import and Domestic A/V Electronics For Home, Mobile, & Marine Entertainment! |
|
|
|
Decibel Garden ® pictures and content of this website are copyrighted 2008-2010 ©
|
